- Index
- Brand
- Ams Racing (25)
- Chevrolet (124)
- Cncrsr (20)
- Comp Cams (63)
- Edelbrock (237)
- Engine Pro (31)
- Enginetech (54)
- General Motors (18)
- Gm Chevrolet (23)
- Holley (303)
- Ict Billet (41)
- Jegs (21)
- Melling (33)
- Moroso (30)
- Motornets (29)
- Oe Quality (21)
- Proform (101)
- Speedmaster (19)
- Speedway Motors (49)
- Weiand (46)
- Other (1113)
- Finish
- Aluminum (6)
- Black (35)
- Black Coated (5)
- Black Crinkle (9)
- Black Powder Coat (6)
- Chevy Orange (7)
- Chrome (19)
- Clean (3)
- Factory Orange (7)
- Gloss Red (7)
- Matte (4)
- Natural (22)
- Painted (5)
- Polished (73)
- Polished Aluminum (16)
- Satin (53)
- Satin Black (12)
- Satin Black Machined (6)
- Stain Oxidation (13)
- Textured Black (13)
- Other (2080)
- Fitment Type
- Material
- 16 Gauge Steel (2)
- 304 Stainless Steel (3)
- Aluminum (401)
- Billet Aluminum (3)
- Cast Aluminum (106)
- Cast Iron (29)
- Chrome (4)
- Chrome Steel (3)
- Die Cast Aluminum (16)
- Diecast (3)
- Forged Aluminum (2)
- Metal (2)
- Mild Steel (3)
- Plastic (30)
- Rear (3)
- Stainless Steel (47)
- Stamped Steel (14)
- Steel (78)
- Tm-77 (2)
- Tri-metal (2)
- Other (1648)
- Type
- Bare Block (8)
- Big Block Chevy (54)
- Camshaft (18)
- Engine Block (23)
- Engine Mount Kit (9)
- Engine Oil Pans (17)
- Engine Rebuild Kit (7)
- Engine Valve Cover (11)
- Engine Water Pump (19)
- Fuse Box (39)
- Hydraulic Flat (28)
- Intake Manifold (92)
- Oil Pan (15)
- Piston Set (13)
- Radiator (22)
- Short Block (8)
- Small Block Chevy (89)
- Valve Cover (28)
- Valve Cover Set (23)
- Valve Covers (26)
- Other (1852)
- Warranty
2011-2017 Chevy Buick GMC 3.6L V6 Bare Engine Block WithMain Caps Note 12640490
PLUMSTEAD AVE, LANSDOWNE PA 19050. 3.6L V6 ENGINE BARE BLOCK.
YOU MUST MATCH YOUR CASTING NUMBER TO CONFIRM FITMENT: 12640490. FITMENT CHART IS ONLY A GUIDE AND WILL NOT GUARANTEE FITMENT. GENUINE OEM BLOCK REMOVED FROM A 2012 CHEVY 3.6L V6 ENGINE.
PLEASE NOTE THAT SOME WATER GOT INSIDE OF THE BLOCK WHILE IT WAS SITTING AND ENDED UP WITH SOME SURFACE RUST ON ONE CYLINDER WALL. WE BALL HONED THE BLOCK AND FOUND AN UNEVEN SURFACE ON THE WALL. SHOULD BE BROUGHT TO A MACHINIST PRIOR TO INSTALL. MAY NEED OVERBORE BUT CAN POSSIBLY BE LEFT STANDARD WITH JUST HONING.NO SPUN OR DAMAGED MAINS.