Edelbrock Performer Plus Camshaft Kit For 1957-1986 Small Block Chevy Engines

  

Edelbrock Performer-Plus Camshaft #2102 is designed for 265-400 Chevy V8 engines from 1957-86 and produce optimum torque from the low-end to the mid-range. Performer-Plus camshafts should be matched with Performer manifolds for vehicles operating from off-idle to 5500 rpm.

The Performer-Plus #2102 is a smooth idling cam for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions.

This cam produced 320HP and 382 Ft Lbs of Torque when paired with Performer EPS intake manifold #2701 and Performer cylinder heads #60909. #D-215-19 for 1957-86 small-block Chevrolet. Camshaft specifications: - Intake duration: 204 Degrees - Exhaust duration: 214 Degrees - Intake lift. 442" - Lobe separation: 112 Degree - Intake Center Line: 107 Degree - Vacuum: 14".

Oil/additive must contain Zinc designed for use with flat tappet camshafts. Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up. Do not allow the engine to run under 2000 rpm for the first 1/2 hour.

Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.

The camshaft works well with high-performance's street applications, Performer RPM cams provide power from 1500 to 6500 rpm. This hydraulic lifter camshaft is dyno-matched to Performer RPM manifolds for high-rpm horsepower while still maintaining acceptable low-end torque. With 10 to 12 inches of manifold vacuum at idle, Performer RPM cams have more lift and duration than most street camshafts. Hydraulic flat tappet lifters are included with each Performer RPM camshaft. Idle Vacuum at 1000 RPM's: 11.

Recommended Valve Springs for OEM heads: Edelbrock part #5703. Use only stock ratio rocker arms. Do not use rotator type valve springs or retainers for this application. You can view and download the instructions. We also have thousands of other High Performance Parts in our. We want you to have the parts as bad as you do.